A long shot but has anyone had any experience of controlling test kit from XOJO, specifically via USB GPIB adaptor from Agilent. We have an old obsolete bit of test kit which has a failing keypad and cant be repaired and we want to create a Gui.
Any info or ideally a simple example project would be fantastic
Cheers
Jon
This bring back memories of the days of programming HP test equipment in Rocky Mountain Basic using GPIB!
I haven’t done any of that in over 25 years but unless Agilent (now Keysight) has changed their protocol significantly, it should be pretty simple. I’m assuming the USB to GPIB adapter looks like a serial port? If so, then you would just set that up as a serial port and write your commands to that. It should not be that difficult.
This topic was automatically closed 182 days after the last reply. New replies are no longer allowed.